Sunday, 10 August 2025

Rear hugger

The hugger is a small mud guard that is fitted to the swing arm. It protects the shock absorber and the back the electric casing from the road crud thrown around by the rear tyre. This upgrade was a little more involved. 


                 

First the rear wheel had to come out. That involved breaking the chain at the link. Loosening the 24mm nut that secure the axle. The axle is removed and then the wheel can be removed. Then the area was thoroughly washed. It is difficult the clean this are with the wheel in place. I had a cup of tea and read the instructions whilst the area dried. 


 

The cable ties which were supplied in the kit were threaded though the upper slot as per the instructions. The swing arm fit in the recess. It is a snug fit and I tapped it home with the handle of my hammer. The cable ties were threaded around the swing arm and out through the bottom slot in the hugger. The ties were pulled tight, a further tap with the hame the make sure the hugger was fully seated and the ties took up a little slack. The hugger was fixed. The trimmed off the excess from the ties and that part of the job was done.

The last part was to refit the back wheel. The axle had to threaded through the near side swing arm picking up the chain adjuster on the way, this whilst holding the tyre off the road and keeping the chain ring and cush drive in the wheel. Wiggling the wheel and axle made it slip through the wheel hub, next the spacer had to be collected then the rear brake assemble this time whist ensure the disc brake pads went neatly either side of the disc rotor. Then to collect the off side chain adjuster then finally slip on the big washer and 24mm axle nut. The axle nut is just nipped up. The drive chain has to reconnected by offering up the chain to accept the split link. It was about now a realised why I have had bikes with shaft drives for years.For whatever reason the chain did not want get close enough for the fitting of the split link. I made sure the chain adjusters were slack, the axle loose enough to move and the chain was on the sprocket at the correct place. There was no reason it should not go back together. The chain is quite worn and lose. Close but not close enough. I remember an odd trick for this situation.

 

A cable tie is looped around the adjacent rollers and pulled tight. I spun the wheel backwards and forwards and low, the link came together. The split link was slid into lace. "o" rings slipped over the pins, the side plate installed a squeezed home finally the circlip was fitted remembering to put it one the right way - the fish swims up stream i.e closed end in the direction of rotation. And don't forget the remove the cable tie. Lastly the chain was adjusted to have 15 - 20mm of free play and the wheel to be on centre line of the bike. That quicker said than done. 

 

The hugger is quite out of sight. However, I expect it will help keep the worst of the road debris of the rear suspension unit and prolong its life.