Having taken my first spin on Gaz the Himalayan it struck me that the handlebars were not in a comfortable position. The last owner was a tall chaps so the handlebars are set for him. Gaz also has the factory brake and clutch levers. The clutch lever is not problem as the clutch action is very light so pulling the lever wit the end of my fingers was not an issue. The brake lever was different matter. The span is really wide. I can just get the end of my flanges on the lever. Himalayan front front brake are quite weak so need a hard squeeze on the lever to make them work. Squeezing is not a problem bu the reach is.
![]() | |
| Factory levers |
I had a mooch about online and found TEC Bike Part based in Newcastle upon Tyne made adjustable span levers for the Gaz. They were not expensive and came with a few days from order. I also ordered them in black. Check them out in the links list. I have changed many lever in my time so the job was not daunting. I did the clutch side first. The first thing to do was take the tension off the cable. The pipe wrench on the clutch actuation lever on the engine case allowed me to disconnect the cable from the clutch thereby taking the tension created by the clutch springs off the cable. It was a simple matter the to remove the pin that holds the hand lever to the handlebar assembly and also acts as a pivot. The cable is turned 90 degrees in the housing on the lever to disconnect the cable from the lever. That done I cleaned everything and pasted the bearing surfaces of the handlebar mount and cable end with multi-purpose grease. The end of the cable was inserted in to the new lever and lever slipped into the handlebar mount. The pivot pin was cleaned, greased and inserted to it position and tightened up. Then back to the clutch arm on the engine cover. The adjuster had been loosened to ease the process. The clutch arm was reconnected to the cable and the adjuster nuts tweaked to the point were the end play in the cable was minimal. Clutch side done. The brake side was much the same except the lever just had to engage the hydraulic brake piston rather than a cable and there were o other adjustments to make. It took about 45 minutes to complete the task
The span adjustment is made by moving a small lever on the lever to one of five settings. 1 being all the way out and 5 being all the way in. The clutch side was set to 2, the brake side was set to 3. On the brake side 5 was too close to the hand grip once the lever was squeezed, it trapped my fingers so I could not put full force on the lever. 3 was a happy medium where I could get a proper grip of the lever to apply the necessary force. I think the black levers look very smart.
Whilst I was dealing with the bars I loosened the switch clusters and lever mountings on both side. I then loosened the hex bolts holding the handlebars to the top yolk. The released the handlebars which I moved back and forth until I decided upon the most comfortable position for me. Position found I nipped up the handlebar hex bolts to finalise the position then re-fastened all the screws and nuts to secure the mounts in their new position. It was not a big change but it made a difference. I went for a spin to check the comfort level and to reset the rear view mirrors.
Whilst I was at this I took the petrol tank off to see what the big red, none factory wire was all about. It powers the auxiliary lamps as day riding lamps, BUT they do not light up as fog lamps. Further investigation required.
I took the bike out for a spin to see if the changes made a difference whilst riding. Well... yes they did. Clutch side was never an issue but having the lever a touch closer made fine clutch adjustment when riding just that bit more comfortable. The brake side was transformed. Getting an easy and secure grip on the front brake lever made for a more confident ride. I did notice that the back brake is way more powerful than the front brake. UK riding is all about front wheel braking, I think the back wheel bias might be a Indian thing. Anyhoo, its all good.


